TORK CRAFT 150mm Magnetic Bit Holder with One Touch Quick Release – 1/4" Hex

Technical Specifications

Features

• 150 mm extension provides extra reach for deep or obstructed fasteners.
• One-touch quick-release sleeve enables rapid bit changes with positive lock-in.
• Magnetic retention securely holds 1/4" hex bits and helps stabilise screws.
• 1/4" hex shank fits standard drill/drivers and bit holders.
• Supplied in carded retail packaging for easy identification and storage.

Benefits

• Faster workflow by allowing bit changes in seconds without adjusting the chuck.
• Improved access to confined or recessed fasteners with the slim 150 mm extension.
• Reduced dropped screws thanks to magnetic retention for easier screw pickup and starting.

Extra Information

• Compatible with standard 1/4" hex insert bits (25–50 mm and longer).
• For best results, insert the bit fully until the locking collar clicks into place, then pull the sleeve to release.
• Use a quality bit matched to the fastener type to minimise cam-out.

Safety

• Disconnect the drill/driver before fitting or removing bits.
• Ensure the bit is fully locked in place and tug gently to confirm before use.
• Avoid excessive side loading, which may bend or snap bits.
• Always wear eye protection, as small fasteners can eject under load.